Warnings - Graco GX21 Cordless Operation, Parts

Warnings

The following warnings are for the setup, use, grounding, maintenance, and repair of this
equipment. The exclamation point symbol alerts you to a general warning and the hazard
symbols refer to procedure-specific risks. When these symbols appear in the body of this
manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols
and warnings not covered in this section may appear throughout the body of this manual where
applicable.
FIRE AND EXPLOSION HAZARD (GROUNDING)
Oil-based and flammable materials can generate static electricity when sprayed or flushed.
Static electricity creates a risk of fire or explosion in the presence of paint or solvent fumes. To
help prevent fire and explosion when using oil-based or flammable materials:
•
Connect the grounding wire and clamp to a true earth ground.
•
If there is static sparking or if you feel a shock, stop operation immediately. Do not use
sprayer until you identify and correct the problem.
•
All parts of the spray system, including the pump, hose assembly, spray gun, and objects
in and around the spray area shall be properly grounded to protect against static discharge
and sparks. Use Graco conductive or grounded high-pressure airless paint sprayer hoses.
Follow Grounding Instructions, page 9.
•
Verify that all containers and collection systems are grounded to prevent static discharge.
Do not use pail liners unless they are anti-static or conductive.
FIRE AND EXPLOSION HAZARD
Flammable fumes, such as solvent and paint fumes, in work area can ignite or explode. To
help prevent fire and explosion:
•
Do not spray flammable or combustible materials near an open flame or sources of ignition
such as cigarettes, motors, and electrical equipment.
•
Do not use a paint or a solvent containing halogenated hydrocarbons.
•
Do not spray flammable or combustible liquids in a confined area.
•
Keep spray area well-ventilated. Keep a good supply of fresh air moving through the area.
•
Keep pump assembly in a well-ventilated area at least 20 feet (6.1 m) from the spray area
when spraying, flushing, cleaning, or servicing. Do not spray pump assembly.
•
Do not smoke in the spray area or spray where sparks or flame is present.
•
Do not operate light switches, engines, or similar spark producing products in the spray
area.
•
Keep area clean and free of paint or solvent containers, rags, and other flammable
materials.
•
Know the contents of the paints and solvents being sprayed. Read all Safety Data Sheets
(SDSs) and container labels provided with the paints and solvents. Follow the paint and
solvent manufacturer's safety instructions.
•
Keep a working fire extinguisher in the work area.
3A8429A
Warnings
5