Table of Contents
Advertisement
Overseas use
Depending on the country, there are limitations on the use of certain
types of radio waves. In some cases, use of the system may lead to a
fine or other penalty.
Moisture condensation
If the PSP
system or UMD™ is brought directly from a cold location
®
to a warm one, moisture may condense on the lens inside the system or
on the UMD™. Should this occur, the system may not operate
properly. In this case, remove the UMD™ and turn off and unplug the
system. Do not put the UMD™ back in until the moisture evaporates
(this may take several hours). If the system still does not operate
properly, visit www.us.playstation.com/psp or contact our technical
support line at 1-800-345-7669 for assistance.
UMD™ handling
• Do not touch the opening on the rear of the disc (recorded surface of
the disc) with your fingers.
• Do not allow dust, sand, foreign objects or other types of dirt to get
on the disc.
• If the UMD™ becomes dirty, gently wipe the exterior and recorded
surfaces of the UMD™ using a soft cloth. Do not use solvents or
other chemicals.
• Do not use a UMD™ that is cracked or warped or has been repaired.
The UMD™ may break inside the PSP® system, leading to injury or
malfunction.
Handling and care of exterior surfaces
Follow the guidelines listed below to help avoid deterioration or
discoloration of the PSP
system:
®
• Do not use solvents or other chemicals to clean the exterior surface.
• Do not allow the system to remain in direct contact with rubber or
vinyl products for an extended period of time.
• Do not use a chemically-treated cleaning cloth to wipe off the
system.
Before using the analog stick
For best results, go to
(Settings)
then with the "System Information" screen displayed, rotate the analog
stick in a circular motion. This will adjust the analog stick's range of
movement.
Cleaning
For safety reasons, unplug the AC power cord from the electrical outlet,
disconnect any other cables and remove the battery pack from the
system before cleaning.
Cleaning the exterior surface and LCD screen
Wipe gently with a soft cloth.
Cleaning the connectors
If the headphones or remote control connectors become dirty, this
could cause noise or interruptions in sound. Wipe the connectors with
a dry, soft cloth to keep in clean condition.
US
(System Settings) and
11
Precautions
Advertisement
Table of Contents
