Weider 8525 User Manual page 8

8. Press a 1 3/4" Square Inner Cap (44) into the top
of a Press Arm (46). Press a 1" Round Inner Cap
(49) into each end of the handle on the Press
Arm.
Attach the Press Arm (46) to one side of the
Press Frame (17) with two 5/16" x 2 1/2" Bolts
(22) and two 5/16" Nylon Locknuts (3).
Assemble the other Press Arm (46) in the same
manner.
9. Identify the Right Arm (48) and the Left Arm (47).
Note the position of the welded bracket on each
Arm. Arm identification is very important for
step 10.
Note: The "V"-Pulleys (6), Long Cable Traps (50),
3/8" x 2 1/2" Bolts (7), and 3/8" Nylon Locknuts
(21) are pre-attached. These have been shown
disassembled for easy part identification.
10. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle on the
Top Frame (55). Note: Be careful not to con-
fuse the Right Arm with the Left Arm (47);
refer to step 9 to identify the Right Arm. Be
sure that the upper end of the Right Arm is
behind the indicated bracket on the Top
Frame.
Tap two 1" Retainers (69) and a 1" Round Cover
Cap (70) onto the right axle. Be sure that the
teeth on the Retainers bend toward the Cover
Cap, as shown in the inset drawing.
Attach the Left Arm (47) in the same manner.
Press a 1 3/4" Square Inner Cap (44) into the
lower ends of the Right and Left Arms (47, 48).
Wet the end of each Arm with soapy water, and
slide a 10" Pad (45) onto the Arm.
All manuals and user guides at all-guides.com
8
8
44
49
49
46
9
50
6
Welded
Brackets
48
10
48
44
45
44
49
46
22
3
17
50
7
6
47
21
55
47
Bracket
Lubricate
69
70
45
55
69
70