Order the "H" part number when installed on horizontal and vertical rear discharge units
Air flow level for auxiliary heat (Aux) must be above the minimum cfm in this table
Auxiliary Heat Electrical Data
Supply
Model
Circuit
208 V
EAS(H)4A
Single
13.7
EAM(H)5A
Single
17.3
EAM(H)8A
Single
27.5
EAM(H)10A
Single
34.7
EAL(H)10A
Single
34.7
Single
52.0
EAL(H)15A
L1/L2
34.7
L3/L4
17.3
Single
69.3
EAL(H)20A
L1/L2
34.7
L3/L4
34.7
All heaters rated single phase 60 cycle and include unit blower load
All fuses type "D" time delay (or HACR circuit breaker in USA)
Supply wire size to be determined by local codes
The manufacturer works continually to improve its products. As a result, the design and specifi cations of each product at the time of order may be changed without notice. Purchaser's approval of this data set signifi es that the equipment is acceptable under the provisions
of the job specifi cation. Statements and other information contained herein are not express warranties and do not form the basis of any bargain between the parties, but are merely the manufacturer's opinion or commendation of its products. York and Affi nity are registered
trademarks of Johnson Controls, Inc., and are used with permission.