Position Of The Noise Plates; Vibrations To Which The Operator Is Subjected - Komatsu Galeo PC14R-2 Operation & Maintenance Manual

SAFETY, NOISE AND VIBRATION PLATES

2.1.3 POSITION OF THE NOISE PLATES

The noise plates must always be legible and in good conditions;
q
for this reason, if they are dirty with dust, oil or grease, it is
necessary to clean them with a solution made of water and
detergent.
Do not use fuel, petrol or solvents.
If the plates are damaged, ask for new ones to Komatsu or to
q
your Komatsu Dealer.
In case of replacement of a component provided with a noise
q
plate, make sure that such a plate is applied also to the new
part.
EXTERNAL NOISE
This value indicates the noise level outside the machine and
q
refers to the noise perceived by persons in the vicinity of the
work area.
NOISE PERCEIVED BY THE OPERATOR
This value indicates the noise level perceived by the operator
q
when seated in driving position.

2.1.4 VIBRATIONS TO WHICH THE OPERATOR IS SUBJECTED

According to the results of the tests carried out to determine the vibrations transmitted to the operator by the
q
machine, the upper limbs are subjected to vibrations lower than 2.5 m/sq.sec., while the seated part of the body
is subjected to vibrations lower than 0.5 m/sq.sec.
24
RKAB5950
2000/14/EC
ISO 6396