Table of Contents
Advertisement
Inserting a Memory Card (GPSMAP 8x17/8x22/8x24/87xx)
NOTE: The memory card reader is not included with the chartplotter. It is sold as a separate accessory. You
must connect a memory card reader or a chartplotter model with a built-in memory card slot to the Garmin
Marine Network.
This device supports up to a 32 GB SD memory card, formatted to FAT32 with speed class 4 or higher. Use of
an 8 GB or higher memory card with speed class 10 is recommended. A memory card is not included with
GPSMAP 8x17/8x22/8x24/87xx models.
1 Open the door
on the memory card reader.
2 Insert the memory card
3 Press the card in until it clicks.
4 Close the card reader door.
Acquiring GPS Satellite Signals
The device may need a clear view of the sky to acquire satellite signals. The time and date are set automatically
based on the GPS position.
1 Turn on the device.
2 Wait while the device locates satellites.
It may take 30 to 60 seconds to acquire satellite signals.
When the device acquires satellite signals,
If the device loses satellite signals,
For more information about GPS, go to garmin.com/aboutGPS. For help acquiring satellite signals, see
device will not acquire GPS signals, page
Selecting the GPS Source
You can select your preferred source for GPS data, if you have more than one GPS source.
1 Select Settings > System > GPS > Source.
2 Select the source for GPS data.
10
with the label facing away from the door.
appears at the top of the Home screen.
disappears and a flashing question mark appears over on the chart.
174.
My
Introduction
Advertisement
Table of Contents
