Electrical Specifications - Ice-O-Matic ELEVATION Series Installation Manual And Owner's Manual

ELEVATION SERIES INSTALLATION GUIDELINES

Electrical Specifications

Refer to the serial plate at the rear of the ice
machine to make sure proper voltage and circuit
breaker size have been supplied. Make sure the
machine is on a dedicated circuit. European
installations require that the electrical supply fixed
wiring must be provided with a disconnect means
having a separation of at least 3mm in all poles.
The ice machines are provided without an
electrical cord set and are designed and agency
approved to be permanently connected.
Units are not approved for GFI outlets
Caution: Electrical connection must be made or a cord
installed by a qualified electrician or there is danger of
an electrical fire.
Adjustments
Level the machine within 1/8 inch in all directions.
Check the water in the Water Sump for proper
level.
Check the ice bridge for proper thickness.
Check the Water Regulating Valve adjustment if
water cooled.
Secure the machine on top of the bin or dispenser.
Attach the ice machine to the bin with the
mounting straps provided with the bin or dispenser.
Insure that the back of the ice machine is flush with
the back of the bin. Proper functioning of the Bin
Door requires the door, when it is opened, to be in
a stable position.
If the ice machine is too far forward on the bin, the
opened door may not be stable, resulting in an
unexpected closing of the bin door. If the ice
machine is to be mounted on a bin or dispenser
other than an Ice-O-Matic, refer to the
manufacturers instructions for machine mounting.
Ice-O-Matic will not be responsible for damage or
injury that results from unexpected closing of the
bin door as a result of the ice machine being too far
forward on the bin.
4