Required Tools And Materials; Decommissioning And Disposal - Siemens RUGGEDCOM RS900 Installation Manual

9
Figure 1.1
POWER LED
ALARM LED
Console Port
RESET Button
Communication Ports
Failsafe Alarm Relay
Power Supply Terminal Blocks
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RS900:
AC power cord (16 AWG)
Multi-mode and/or single-mode fiber optic cables
CAT-5 Ethernet cables
Flathead screwdriver
Phillips screwdriver
4 x #6-32 screws
1.4

Decommissioning and Disposal

Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
RUGGEDCOM RS900
Installation Manual, 12/2020, C79000-G8976-1024-12
Power Supply Terminal Block
RUGGEDCOM RS900
Tools/Materials
Illuminates green during boot up and when power is supplied to the
device.
Illuminates red when an alarm condition exists.
The serial console port is for interfacing directly with the device
and accessing initial management functions. For information
about connecting to the device via the serial console port, refer to
"Connecting to the Device (Page
Shuts down and restarts the device. For more information, refer to
"Resetting the Device (Page
Communication ports in general receive and transmit data, as
well as provide access to the RUGGEDCOM ROS Web interface.
For more information about the various ports available, refer to
"Communication Ports (Page
Latches to default state when a power disruption or other alarm
condition occurs. For more information, refer to:
• "Connecting the Failsafe Alarm Relay (Page 10)"
• "Failsafe Alarm Relay Specifications (Page 24)"
Pluggable terminal blocks for connecting one or more power
sources. For more information, refer to
11)" and "Power Supply Specifications (Page
For connecting power to the device.
For connecting the device to a LAN.
For connecting the device to a LAN.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
Introduction
1.3 Required Tools and Materials
17)".
18)".
19)".
"Connecting Power (Page
23)".
Purpose
3