Adjustments - Scotsman Prodigy Plus C0830 Installation And User Manual

C0322 through C1030
Air and Water Cooled User Manual

Adjustments

Bridge Thickness - For the Service Tech Only
1. Push and hold Off till the machine stops.
2. Remove evaporator cover.
3. Remove curtain.
4. Use a hex wrench and rotate the bridge thickness
adjustment screw in 1/8 turn increments CW
to increase bridge thickness. Rotate CCW to
decrease bridge thickness.
Caution: Do not make the bridge too thin or the
machine will not harvest properly. Bridge thickness
adjustments are not covered by warranty.
5. Return curtain and evaporator cover to their
normal positions.
6. Push and release the On button. Check next
harvest of ice. Repeat steps 1-6 if needed.
Water Purge Setting
The water purge is factory set to the automatic
position, suitable for most water conditions. The
setting can be changed to one of 5 manual settings or
left on automatic.
Purge setting 1 - Minimum
Water Type RO water or
equivalent
To set:
1. Switch the machine OFF by holding the Off button
in until a number or the letter A shows on the
display.
2. Press and release the On button repeatedly until
the number on the display corresponds to the
desired setting.
3. Press and release the Off switch again to return to
the normal control state.
2 - Moderate 3 - Standard
Low TDS Use for typical
non - RO water
water
November 2012
Page 14
Ice Bridge Thickness Measurement
Note: Indentations may be deeper on C0322 and C0330
1/8-3/16"
bridge
Too Big Just Right
Bridge Thickness Adjustment Mechanism
4 - Heavy 5 - Maximum
High TDS Very High TDS
water water
Note: Water cooled models, the refrigeration system
discharge pressure is factory set at 245 PSIG,
which should yield a freeze cycle discharge water
temperature of about 105-110 degrees F. Adjust if
necessary.
Too Small
Adjustment
Screw
A - Automatic
Any with
conductivity not
less than 10
microSiemens/
cm