LENCO DIR-140 User Manual page 23


If RDS information is available, by default the service name (i.e. station name) is displayed. You
can cycle through further RDS information by pressing Info. Each time you press Info, another
set of information is displayed, cycling through RDS radio text, RDS programme type, frequency
and today's date.

If no RDS information is available, the currently tuned frequency is shown.
10.3 Settings
Scan settings
By default, FM scan stops at any available station. This may result in a poor signal-to-noise ratio
(hiss) from weak stations. To change the scan setting to stop only at stations with good signal
strength, select Menu > Scan setting > Strong stations only? > Yes
Audio Settings
By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a poor
signal-to-noise ratio (hiss). To play weak stations in mono, select Menu > Audio setting > FM weak
reception: Listen in mono only > Yes.
11. Bluetooth
Bluetooth mode allows Bluetooth devices to pair with the radio, stream music and displays
information about the track playing. To enter Bluetooth Audio mode, either press Mode to cycle
through the listening modes until Bluetooth Audio is displayed, or select Menu > Main menu >
Bluetooth. The Bluetooth Audio menu offers the following options:

Setup Bluetooth

View Details

System Settings

Main Menu
11.1 To pair a Bluetooth device with the radio
In Bluetooth mode, on your radio press Menu > Setup Bluetooth, this puts the radio into
discoverable mode. The screen shows the Bluetooth name of the radio (Lenco DIR-140). On your
Bluetooth smart device, make sure you Bluetooth is on and scan for devices and select 'Lenco DIR-
140' of the Bluetooth devices list
11.2 Switch to another paired Bluetooth device
In Bluetooth mode, on the radio select Menu > View details > Paired Device List then select the
required device from the list.
11.3 Control from radio
While in Bluetooth mode you can pause, play, jump to next track and jump to previous track (in the
playlist on the controlling Bluetooth device) using the buttons available on the radio.
11.4 Bluetooth connection details
For information on the current state of the Bluetooth connection and paired Bluetooth devices, in
Bluetooth mode select Menu > View details, the menu offers the following options:
23