LENCO DIR-140 User Manual page 14

6.3.2 WPS setup (Wi-Fi Protected Setup)
Radio prompts you to press the connect button on the router and then press the select control. For
more information on setting up a WPS encrypted network, see your WPS router's instructions.
6.3.3 View settings
Displays the settings details for the current network setup, including:

Active connections

MAC address

Wlan region

DHCP

SSID

IP Address

Subnet mask

Gateway address

Primary DNS

Secondary DNS
6.3.4 Manual settings
Choose DHCP enable/disable
6.3.5 NetRemote PIN setup
Allows you to define a PIN number to be entered before being able to connect to radio remotely
over a network
6.3.6 Network profile
This displays a list of the networks remembered by radio (up to a maximum of 4). You can see the list
of registered networks through Menu > System settings > Network > Network profile>. From here
you can delete unwanted networks by turning and press OK then confirming delete Yes.
6.3.7 Clear network settings
This option will clear current network settings, to allow you to join an alternative network more
easily.
6.3.8 Keep network connected
This option allows you to define whether radio remains connected to its network in Standby mode
and when not in Internet radio mode. This is necessary for remote operation and audio streaming in
Music player mode.
Note: This option is forced to 'Yes' to keep the network connected if connection is configured using
the UNDOK app.
Note: It is possible to disable the WIFI network.
Method 1: When the radio is on, longpress the standby button. Radio will go into standby with WIFI
disabled.
14