Monitoring Optical Power
1
Clean the tester's input port and the patch cord and
source connectors.
2
Use the patch cord to connect the source to the tester's
input port, as shown in Figure 17. Turn on the source.
3
Turn the rotary switch to MONITOR. If the media type is
not set to Fiber, press
J
Change Media to change it.
4
Select Power Meter. You do not need to select a fiber
type or test limit.
5
Select the correct wavelength; then press
To change the wavelength after starting the test, press
Change λ.
L
Monitoring Optical Power
P
.
37