Table of Contents
Advertisement
EN
Before performing any servicing opera-
tions:
a. Place the machine on a flat surface.
b. Activate the parking brake (10:B)
c. Stop the engine.
d. Remove the key from the ignition.
Authorized service workshops carry out guaran-
teed repairs and maintenance.
Always use genuine spare parts.
Genuine STIGA SpA spare parts and
accessories were designed specifically
for STIGA SpA machines.
Please remember that non-genuine
spare parts and accessories have not
been verified or approved by STIGA
SpA.
The use of non-genuine spare parts
and accessories could adversely affect
machine operation and safety.
STIGA SpA shall decline all liability in
the event of injuries or damages caused
by such parts.
Genuine spare parts are supplied by
authorized assistance workshops and
dealers.
It is advisable to send your machine
once a year to an authorized service
workshop for servicing, assistance and
safety device inspection.
11 STORAGE
1. Empty the fuel tank:
• Start the machine's engine and leave it
running until it stops.
1. Change the oil when the engine is still warm.
2. Thoroughly clean the whole machine. It is
particularly important to clean the bottom
side of the cutting means assembly.
3. If the paintwork is damaged, touch it up to
prevent rust.
4. Place the machine in a covered, dry place.
For machines with electric starter:
If the storage temperature is correct, simply
recharge the batter every four months.
Charge the battery before putting the
machine into storage.
The battery can be seriously damaged
it if is put into storage flat.
22
ENGLISH
(Translation of the Original Instructions)
12 TERMS OF PURCHASE
The warranty covers all material and manufactu-
ring defects.
The user must follow all the instructions provided
in the accompanying documentation.
The warranty does not cover damages caused by:
• failure to become familiar with the
documentation accompanying the machine,
• carelessness,
• incorrect or prohibited use or assembly,
• use of non-genuine spare parts,
• use of accessories not supplied or approved by
STIGA S.p.A..
The warranty does not cover:
• Normal wear and tear on wear parts such as the
auger, etc..
• normal wear and tear
• engines. Engines are covered by the warranty
provided by the relative manufacturer in
compliance with the specified terms and
conditions.
The purchaser is protected by his own national
legislation. The purchaser's rights envisaged by
the national laws in his own country are not in any
way restricted by this warranty.
Advertisement
Table of Contents
