Attaching The Lead Wires; Electrode Selection And Care - Apex Digital Digi-Stim GM320T SD TENS Instruction Manual

ATTACHING THE LEAD WIRES

The lead wires provided with the device insert into the jack sockets located on top of the unit. Holding
the insulated portion of the connector, and pushing the plug end of the wire into one of the jacks. After
connecting the wires to the stimulator, attach each wire to an electrode.
Lead wires provided with the device are compliant with mandatory compliance standards as set forth
by the FDA.
Note: Use carefully when you plug and unplug the wires. Pulling on the lead wire instead of its insulated
connector may cause wire breakage.
Caution: Never insert the plug of the lead wire into an AC power supply socket.

ELECTRODE SELECTION AND CARE

Your physician/practitioner should decide which type of electrode is best for your condition. Follow
application procedures outlined in electrode packaging to maintain stimulation and prevent skin irrita-
tion. The electrode packaging will provide instruction for care, maintenance and proper storage of your
electrodes.
Be sure to use the electrodes provided by the manufacturer and/or the similar FDA legally marketed
electrode in particular the same cross section area.
9