Reparation instructions
Removing/installation of hydrostatic
transmission Rider 14 Pro
1
• Block-up the machine in front of the rear frame
and remove the back wheels.
• Remove the transmission cover.
2
• Release the tensioning wheel spring (1).
• Remove the circlip (2), lift away the washer and
fan from the input axle.
32
– English
3
• Detach the drive belt (1) and release the brake
wire spring (2).
• Disconnect the brake wire (3) and dismantle the
throttle control (4).
• Remove the spring and the disengaged clutch
control.
4
Disconnect the contact (1) and take off the hose
(2). Ensure that the oil does not run out, e.g. tie up
the hose higher than the oil level in the container.