Replacing Bushings; Installation Of Swing Axle - Husqvarna Rider 11 Workshop Manual

3
Remove the circlip and washer from the swing
axle's inner holder (1) and pull the swing axle out
backwards.
If the dust protection (2) is damaged, this should be
replaced by a new one.
Replacing bushings Rider 14 Pro
Once the swing axle has been removed the
bushings fitted to the rear frame must be replaced.
They can be removed with a standard drift.
Fit the new bushings with the aid of the standard
drift, making sure that the channels in the bushings
run horizontally. It is important that the outer edge
of the outermost bushing is flush with the outer
edge of the hole.
Lubricate the bushings with a lithium-based grease.

Installation of swing axle

1
• Grease half of the axle (the half that has not
been turned down) and press it from the back
into the steering spindle (see diagram).
• Attach the washer and circlip on the swing axle's
inner holder.
• Fix the dust guard (with a thin lip behind) approx.
2/3 of the way in on the axle and lubricate the
axle on both sides of the dust guard.
2
Roll the rear frame forwards and press it in on the
swing axle.
Reparation instructions
29
English –