Replacing Articulated Steering Bearing - Husqvarna Rider 11 Workshop Manual

Replacing articulated steering bearing

1
• Remove the engine according to the earlier
description (see "Removing engine").
• Block up the ride-on mower in front of the
articulated steering.
2
• Release the tensioning wheel spring (1).
• Release the clutch, gear and brake wire (2, 3
and 4) and remove the wires' holder plates (5
and 6).
3
• Loosen the steering wires (1) and remove the
steering rim.
• Remove the pulley (2). Move the lower part
forwards, the upper part backwards and detach
the pulley.
4
Detach the articulation spring. This spring is
strongly tensioned and should be secured with tool
no. 506 89 93-01 before the nut is removed.
!
WARNING!
The articulation spring is strongly
tensioned and can cause injury if it
flies off. Wear safety glasses and
gloves when removing/attaching
the spring.
Reparation instructions
27
English –