Table of Contents
Advertisement
Steps
1. Using the alignment posts, place the speakers on the palm-rest and keyboard assembly.
NOTE:
Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3. Connect the speaker cable to the system board.
Next steps
1. Install the
M.2 2230 solid-state
2. Install the
M.2 2280 solid-state
3. Install the
base
cover.
4. Follow the procedure in
Heat sink
Removing the heat sink
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
NOTE:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
NOTE:
For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin
can reduce the heat transfer capability of the thermal grease.
The following images indicate the location of the heat sink and provides a visual representation of the removal procedure.
drive, if applicable.
drive, if applicable.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
35
Advertisement
Table of Contents
