Table of Contents
Advertisement
2. Slide the cover plate backward or forward to
adjust the travel of the lever and tighten the
screws.
3. Drive the machine and check the full forward
tracking.
4. Repeat steps 1 through 3 until desired tracking
is obtained.
Figure 39
RH Motion Control Shown
1. Screw
2. Cover plate
Caster Pivot Bearings
Pre-Load Adjustment
Remove dust cap from caster and tighten nyloc nut
until washers are flat and back off 1/4 of a turn
to properly set the pre-load on the bearings. If
disassembled, make sure the spring disc washers are
reinstalled as shown in Figure 40.
3. Motion control lever
1. Spring disc washers
LPG Regulator
No adjustments necessary. If the engine is not
running properly, contact an Authorized Kohler
Service Dealer
49
Maintenance
Figure 40
Advertisement
Table of Contents
