OPTIONAL OPERATION
32
Installer Setting-Dry Contact Mode Setting
Dry contact function is the function that is possible to use only when dry contact equipment is
separately purchased/setup.
NOTE
!
What is Dry Contact?
Like hotel card key and body perception sensor, it is the signal of the point of contact when
using air-conditioner by interlocking.
- Please refer to dry contact manual for more details.
Press and hold
1
than 3 seconds to enter the installer
settings mode.
- If pressing only once briefly, it will
enter the user settings mode.
Make sure to press and hold for more
than 3 seconds.
Move to the Dry Contact Mode Settings in the
2
menu using
button and then it displays
as below.
Select the Dry Contact Mode using
3
button.
Code value for
Set value
dry contact
4
Press
button to save the setting.
5
Press
button to exit.
If no button is selected for about
25 seconds after setup, it exits the setup
mode automatically.
If the
button is not selected before you
exit, the changes will not apply.
button for more
❈
Set value for dry contact
00 : Manual
01 : Auto