Installer Setting - Static Pressure Setting - LG ABNQ18GM1T0 Installation Manual

Installer Setting - Static Pressure Setting

This function is applied to only duct type. Setting this in other cases will cause malfunction.
<Static Pressure Setting Table>
Pressure selection
01
02
03
04
Press and hold
1
than 3 seconds to enter the installer
settings mode.
- If pressing only once briefly, it will
enter the user settings mode.
Make sure to press and hold for more
than 3 seconds.
Move to the Master/slave selection in the
2
menu using
as below.
Select the remote control master/slave
3
using
Code value for
static pressure
4
Press
5
Press
If no button is selected for about
25 seconds after setup, it exits the setup
mode automatically.
If the
exit, the changes will not apply.
Zone state
V-H Variable
F-H
V-L Variable
F-L
OPTIONAL OPERATION
button for more
button and then it displays
button.
Set value
❈
Set value for static pressure
01 : V-H
02 : F-H
03 : V-L
04 : F-L
button to save the setting.
button to exit.
button is not selected before you
Function
ESP standard value
Fixed
Fixed
33
High
High
Low
Low