Installer Setting - E.s.p - LG ABNQ18GM1T0 Installation Manual

Installer Setting - E.S.P.

This is the function that decides the strength of the wind for each wind level and because this
function is to make the installation easier.
- If you set ESP incorrectly, the air conditioner may malfunction.
- This setting must be carried out by a certificated-technician.
Function code,
ESP code
ESP value
OPTIONAL OPERATION
Press and hold
1
than 3 seconds to enter the installer
settings mode.
- If pressing only once briefly, it will
enter the user settings mode.
Make sure to press and hold for more
than 3 seconds.
Once entered the ESP setting mode
2
using button, it displays as below.
Select the level of ESP Fan Speed using
3
button. There are 5 levels in the
fan speed, SLOW → LOW → MED →
HIGH → POW.
ESP level : 01~05
❈ The ESP set value can be
programmed 0~225.
Move to the ESP value settings using
4
button.
The ESP value numbers will blink.
(It is set 000 by default.)
Set the ESP value using
5
(The ESP value can be set from 1 up to
255, and 1 is the smallest value and
255 is the largest value.)
button for more
ESP ESP ESP value
Code value Fan Speed level
ESP level Fan Speed
01 SLOW
02 LOW
03 MED
04 HIGH
05 POW.
button.
29