Yearly Procedures; Cable Adjustment - CYBEX Bravo Series Owner's Manual

Yearly Procedures

Replace all cables and belts annually

Cable Adjustment

Tools Required
• 9/16" Wrench (2)
• Hammer
• 3/16" Pin punch
Four types of cable tension adjustment are used on Cybex Strength Systems:
Jam Nut Adjustment
This type of adjustment uses a jam nut and a tension adjustment nut at the cable cam end as the primary
adjustment. The other end of the cable usually contains a roll pin adjustment.
Rod End Adjustment
This type of adjustment uses a socket head cap screw (SHCS) securing a cable rod end bearing to the machine.
Primary adjustment is by turning the rod end bearing. The other end of the cable usually contains a roll pin cable
adjustment.
Roll Pin Adjustment
This type of adjustment uses a roll pin and series of holes in the weight stack top weight connector.
Item
1
2 Tension adjustment nut
Item
1
2
3
4 Cable rod end bearing
5
Page 23 of 27
Description
Jam nut
Description
Cable end
SHCS
Jam nut
Nylon locknut
Qty.
1
1
Qty.
1
1
1
1
1