EverFocus EBA2580 eZ.HD Series User Manual page 4

a. If you want to wire the cables from the Side Cut on the Camera Base:
Attach the Camera Body to the Camera Base and run the cables through
the Camera Base, and then place the cable under the Side Cut. Finally,
screw the Camera Base to the surface with the supplied 4 Screws.
b. If you want to wire the cables through the surface:
Attach and screw the Camera Base to the surface with the supplied 4
Screws, and then attach the Camera Body to the Camera Base.
Camera Body
4. Screw back the Outer Housing and adjust camera angle simultaneously.
180
°
180
Camera Body
Camera Base
360
°
°
Wall
Camera Base
Side Cut
Wall
3