Toro Reelmaster Edge Series Operator's Manual page 19

5. Tighten the spring-tension nut until the spring is
collapsed, then back off 1/2 turn
1. Spring-tension nut
Installing the Bedknife
1. Remove the rust, scale, and corrosion from the
bedbar surface and apply a thin layer of oil to
the bedbar surface.
2. Clean the screw threads.
3. Apply anti-seize compound to the screws and
install the bedknife to the bedbar as follows
(Figure 33):
1. Bedbar
2. Bedknife
A. Torque the 2 outer screws to 1 N∙m (10
in-lb); refer to
B. Working form the center of the bedknife,
torque the screws to 23 to 28 N∙m (200 to
250 in-lb); refer to
(Figure
Figure 32
2. Spring
Figure 33
3. Screw
Figure 34.
Figure 34.
32).
g006505
1. Bedknife screw tool
2. Install and torque these
first to 1 N∙m (10 in-lb).
4. Grind the bedknife.
g279161
19
Figure 34
3. Torque to 23 to 28 N∙m
(200 to 250 in-lb).
g279162