Midi Function - Fostex FD-4 Service Manual

FD-4
The followings are examples of error message when the FD-4 is not working properly.
• SCSI function
• Digital Signal in/out (Fs: 44.1kHz)
• Vari-pitch function
4-6. Offset Display
16
SYNC OUT
CLK
AUTO
44.1kHz
SYNC OUT
CLK
AUTO
VARI PITCH
SYNC OUT
CLK
AUTO
SYNC OUT
CLK
AUTO
H M S DF
SYNC OUT
CLK
AUTO

• MIDI function

DRIVE
SCSI
A.PUNCH
• Digital Signal in/out (Fs: 32kHz)
DRIVE
SCSI
A.PUNCH
DRIVE
SCSI
A.PUNCH
This mode determines if the offset value against a master
: Blinking
machine should be displayed or not when the FD-4 is
working as a slave machine.
If you would like to turn ON the offset display, press the
EXECUTE/YES key while "?" is blinking. (The default
DRIVE
SCSI
setting is "off".) Then, turn the jog dial C.W and press the
A.PUNCH
EXECUTE/YES key.
In order to display the offset value, select the "MTC" by the
TIME BASE key and the "REMAINING TIME" as DISP
OFFSET
SEL key.
SF
CAUTION:
1. There might be a case that the percentage display does
DRIVE
SCSI
not indicate "0.0%" exactly when the FD-4 is working as
A.PUNCH
a slave machine and is synchronizing with a master
machine. This is caused by a difference of internal clock
between both machines but there is nothing wrong with it.
2. The two-digit numbers displayed in the right of percentage
display ("05" in the left example) is only for software
programming purpose.
SYNC OUT DRIVE
CLK SCSI
AUTO A.PUNCH
SYNC OUT DRIVE
CLK SCSI
AUTO A.PUNCH