Fostex FD-4 Service Manual page 15

<Cable Connection in "Self Check" Mode>
POWER
1 2 3 4 L R
AUX RTN 2
R MON OUT L R ST OUT L 2 AUX SEND 1
R
SCSI
External
SCSI Drive
To start the Self Check mode, press the EXECUTE/YES
key when "?" is blinking (condition indicated in the previous
page).
As shown in the left, "SelfCheck", "Initial..", name of
SYNC OUT DRIVE
CLK SCSI connected SCSI drive (The example in the left shows that
AUTO A.PUNCH
the ZIP drive is connected to the FD-4 SCSI port.) and "ATA
Bus C (Check)" appear on the FD-4 LCD display in order.
Since a 2.5" internal E-IDE hard disk drive is not installed
in the FD-4, the Self Check mode comes to a standstill at
"ATA Bus Check" test.
SYNC OUT DRIVE
In order to continue the Self Check mode, press the
CLK SCSI
AUTO A.PUNCH
EXECUTE/YES key.
If the FD-4 is in a good shape, "Check OK!" will be displayed
and the FD-4 is automatically put into Input Monitor mode
with all the RECORD TRACK LEDs and RECORD LED
flashing after checking the points mentioned in the previous
page. In this condition, if a signal is applied to the FD-4
SYNC OUT DRIVE
RECORDER IN (L, R) jacks, its level can be monitored on
CLK SCSI
AUTO A.PUNCH
the bargraph level meter.
To quit the Self Check mode, press the EXIT/NO key when
"Check OK!" is displayed.
SYNC OUT DRIVE
CLK SCSI
AUTO A.PUNCH
SYNC OUT DRIVE
CLK SCSI
AUTO A.PUNCH
INPUT 4
AUX RTN 1
MONO/L R MONO/L 4 INSERT 3
DATA DATA PUNCH MIDI MIDI RECORDER IN
IN OUT IN/OUT IN OUT R
Optical MIDI cable Apply
audio signal.
Cable
INPUT 3
L
FD-4
15