There is no command line access and the WatchGuard XCS runs as a closed system, preventing accidental or deliberate misconfiguration by administrators, which is a common cause of security vulnerabilities.
Put it in a secure area, such as a locked room, to keep the device from people who do not have permission to use it. Connect it to a conditioned power supply to prevent damage from sudden power changes. Other environmental requirements for the WatchGuard XCS device: Operating temperature 0 to 40°C (32 to 104°F) Non-operating temperature –40 to 70°C (–40 to 158°F)
Caution You must disconnect the AC power cord from both power supplies before you remove the cover cover of the XCS device. If you open the cover without prior authorization from WatchGuard, the Hardware Warranty is voided. Hardware Guide...
Page 6
Hardware Specifications Hard Drive Carriers Each hard drive carrier has two indicators: Status: The upper status indicator is green during normal operation. When the status flashes red, this indicates the drive is rebuilding. When the status is solid red, it indicates a drive failure. ...
Hardware Specifications Rear View This is a close-up of the rear of the device. USB Interfaces There are two USB interfaces that support additional peripherals, for example. a USB keyboard for use with the XCS device console. VGA Video Interface (Console) You can use the VGA video connector to connect a monitor and view the XCS device console screen.
Hardware Specifications Replace a Power Supply Your XCS device is equipped with dual power supplies. If one of the power supplies fails, the XCS device will continue normal operation with the remaining power supply. It is not necessary to turn off the XCS device to replace a failed power supply. Caution The power supply can be extremely hot when removed.
Hardware Specifications Network Interfaces This is a close-up of the network interfaces on the rear of the device. Onboard Network Interfaces The XCS device has four network interfaces. The network interfaces have standard RJ45 connectors. Network Interface Indicators Each network interface has a pair of indicators. The left indicator is the activity indicator for the interface.
WatchGuard Technologies, Inc. (“WatchGuard”) and you agree as set forth below or on the reverse side of this card, as applicable: 1.
Page 12
WITH REGARD TO ANY PRODUCT WILL IN NO EVENT EXCEED THE PURCHASE PRICE PAID BY YOU FOR SUCH PRODUCT. THIS SHALL BE TRUE EVEN IN THE EVENT OF THE FAILURE OF ANY AGREED REMEDY. IN NO EVENT WILL WATCHGUARD BE...
Legal and Regulatory Information Safety Notices All WatchGuard products are designed and tested to meet strict safety requirements. These requirements include product safety approvals and other global compliance standards. Please read the following instructions carefully before operating the product, and refer to them as needed to ensure the continued safe operation of your product.
Page 15
La batería de litio utilizada en el dispositivo de seguridad no podrá ser sustituido por el usuario. Devuelva el aparato a un centro de servicio autorizado de WatchGuard para el reemplazo con el mismo tipo o equivalente recomendada por el fabricante. Si, por cualquier razón, el aparato de la batería o de seguridad deben ser eliminados, se deben seguir las instrucciones del fabricante de la batería.
Consult the dealer or an experienced radio/TV technician for help. CE Notice The CE symbol on your WatchGuard Technologies equipment indicates that it is in compliance with the Electromagnetic Compatibility (EMC) directive and the Low Voltage Directive (LVD) of the European Union (EU).
Legal and Regulatory Information Japan VCCI Notice Mexico Notice La operación de este equipo está sujeta a las siguientes dos condiciones: 1. es posible que este equipo o dispositivo no cause interferencia perjudicial y 2. este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su propia operación no deseada.
Substances (“RoHS directive”‘) that became valid on July 1, 2006. It states that all new electrical and electronic equipment put on the market within the member states must not contain certain hazardous materials. The WatchGuard XCS complies with the European Union’s R0HS directive 2002/95/EC and similar regulations that may be adopted by other countries for European Sales.
WEEE statutes, and that the recovery of our product per the specific EU country legislative requirements is seamless for our product’s end users. If you have a WatchGuard product that is at its end of life and needs to be disposed of, please contact WatchGuard Customer Care Department at: U.S. Customers: 877.232.3531 International Customers: +1.206.613.0456...