BenQ G Series User Manual page 42

The image is displaced in one direction.
Read the instructions on the link
select the correct resolution, refresh rate and make adjustments based on these instructions.
Faint shadow from the static image displayed is visible on the screen.
• Activate the power management function to let your computer and monitor go into a low
power "sleep" mode when not actively in use.
• Use a screensaver to prevent the occurrence of image retention.
Power LED indicator
The LED indicator is green or orange.
• If the LED lights up in solid green, the monitor is powered on.
• If the LED is illuminated in green and there is a message
means you are using a display mode that this monitor does not support, please change the
setting to one of the supported mode. Please read the
from the link
• If the LED is illuminated in orange, the power management mode is active. Press any button
on the computer keyboard or move the mouse. If that does not help, check the signal cable
connectors. If any pin is bent or broken off, please contact your dealer to get necessary
support.
• If the LED is off, check the power supply mains socket, the external power supply and the
mains switch.
OSD controls
The OSD controls are inaccessible.
To unlock the OSD controls when it is preset to be locked, press and hold any key for 10
seconds.
OSD messages
Out of Range
A message
If there is a message
means computer compatibility caused by operating system or graphic card. The system will
adjust the refresh rate automatically. Just wait until the operating system is launched.
Audio
No sound can be heard from the connected external speakers.
• Remove your headphone (if the headphone is connected to the monitor).
• Check whether the headphone jack is properly connected.
• If the external speakers are USB-powered, check whether the USB connection is OK.
• Increase the volume (volume may be muted or too low) on the external speakers.
42 Troubleshooting
"Adjusting the Screen Resolution"
"Adjusting the Screen Resolution"
on the screen during computer boot up process.
Out of Range
.
on the screen during computer boot up process, this
on the CD, and then
Out of Range
on the screen, this
"Preset display modes"
section