Shelf Manager Fan And Power Control - Fortinet FortiGate FortiGate-5140 User Manual

FortiGate-5140 shelf managers

Shelf Manager fan and power control

12
Figure 5: FortiGate-5140 shelf manager front panel
Reset
ETH 0 and 1 network
activity LEDs
Button
5000SM
10/100
link/Act
10/100
link/Act
Mounting ETH0 Status
Knot 100base-T LEDs
Ethernet
Table 5 lists and describes the FortiGate-5140 shelf manager LEDs.
Table 5: FortiGate-5140 shelf manager LEDs
LED State
ETH 0 10/100 Yellow
ETH 1
link/Act Green
Off
STATUS Green
Red
HOT SWAP Off
Blue
Long blink The shelf manager is starting up after being inserted into the
Short
blink
The FortiGate-5140 shelf managers monitor the internal temperature of the
FortiGate-5140 chassis and adjust the operating speed of the FortiGate-5140
chassis cooling fans as required. If the temperature in the chassis becomes too
high, the shelf managers can also power down FortiGate-5000 modules installed
in the chassis to help reduce the temperature.
When the chassis is first powered on all cooling fans run at full speed. Once the
shelf manager is up and running, the shelf manager reduces cooling fan speeds to
maintain an optimum temperature in the chassis. If shelf managers are not
installed or not operating correctly the FortiGate-5140 chassis cooling fans always
operate at full speed.
Hot Swap
LED
Extraction
lever
Description
The Ethernet interface is connected at 100 Mbps.
Blinking LED indicates network traffic.
No link.
This shelf manager is operating normally as the active shelf
manager. Usually the primary shelf manager operates as
the active shelf manager.
This shelf manager is operating normally as the backup
shelf manager. Usually the secondary shelf manager
operates as the standby shelf manager.
The shelf manager is not ready to be removed.
The shelf manager is ready to be removed.
chassis.
The shelf manager is shutting down in preparation for being
removed from the chassis.
FortiGate-5140 chassis
FortiGate-5140 Chassis Guide
01-30000-0396-20070201