Using The Setup Wizard; Reconnecting To The Web-Based Manager - Fortinet FortiGate FortiGate-50A Installation Manual
Antivirus firewalls
Hide thumbs
Also See for FortiGate FortiGate-50A:
- Administration manual (374 pages) ,
- Quick start manual (2 pages) ,
- Install manual (84 pages)
Table of Contents
Advertisement
Transparent mode installation
Using the setup wizard
Reconnecting to the web-based manager
FortiGate-50A Installation Guide
Example
If the default gateway IP is 204.23.1.2 and this gateway is connected to port 2:
config router static
edit 1
set dst 0.0.0.0 0.0.0.0
set gateway 204.23.1.2
set device port2
end
From the web-based manager, you can use the setup wizard to begin the initial
configuration of the FortiGate unit. For information about connecting to the web-based
manager, see
"Connecting to the web-based manager" on page
The first time you connect to the FortiGate unit, it is configured to run in NAT/Route
mode.
To switch to Transparent mode using the web-based manager
1
Go to System > Status.
2
Select Change beside the Operation Mode.
3
Select Transparent in the Operation Mode list.
4
Select OK.
To reconnect to the web-based manager, change the IP address of the management
computer to 10.10.10.2. Connect to the internal interface and browse to https://
followed by the Transparent mode management IP address. The default FortiGate
Transparent mode management IP address is 10.10.10.1.
To start the setup wizard
1
Select Easy Setup Wizard (the middle button in the upper-right corner of the
web-based manager).
2
Use the information that you gathered in
Select the Next button to step through the wizard pages.
3
Confirm your configuration settings, and then select Finish and Close.
If you changed the IP address of the management interface while you were using the
setup wizard, you must reconnect to the web-based manager using the new IP
address. Browse to https:// followed by the new IP address of the management
interface. Otherwise, you can reconnect to the web-based manager by browsing to
https://10.10.10.1. If you connect to the management interface through a router, make
sure that you have added a default gateway for that router to the management IP
default gateway field.
01-28008-0017-20050128
Table 9 on page 38
to fill in the wizard fields.
Using the setup wizard
16.
41
Advertisement
Table of Contents
