Brake Rod Replacement - Schwinn 9-7310 Service Manual

Brake Rod Replacement

1. Use a 5mm hex key to remove the screws securing the
right side sweatguard to the bike.
2. Remove the retaining screw (blue) from the top cap, then
pull out the front pop pin (blue), then pull upwards on the
brake top cap (yellow) to remove it.
3. Turn the brake knob clockwise to lower the brake assem-
bly down onto the flywheel.
4. Use a 27mm open-ended wrench to remove the brake rod
assembly while turning clockwise to disconnect the brake
rod assembly from the brake adjustment nut
Page 20