Verifying The Front Control Buttons And Lcd Configuration; Verify The Connection; Using The Command Line Interface; Configuring The Fortigate Unit To Operate In Nat/Route Mode - Fortinet FortiGate FortiGate-3000 Install Manual

NAT/Route mode installation

Using the command line interface

40

Verifying the front control buttons and LCD configuration

To verify the interface settings entered from the front control buttons and LCD, go
to the web-based manager, System > Network > Interface. The interface IP
addresses entered from the front control buttons and LCD should be displayed.

Verify the connection

To verify your connection, try the following:
• browse to www.fortinet.com
• retrieve or send email from your email account
If you cannot browse to the web site or retrieve/send email from your account,
review the previous steps to ensure all information was entered correctly and try
again.
You can also configure the FortiGate unit using the command line interface (CLI).
For information about connecting to the CLI, see
page 22.

Configuring the FortiGate unit to operate in NAT/Route mode

Use the information you gathered in
following procedures.
To add/change the administrator password
1 Log into the CLI.
2 Change the admin administrator password. Enter:
config system admin
edit admin
set password <psswrd>
end
To configure interfaces
1 Log into the CLI.
2 Set the IP address and netmask of the internal interface to the internal IP address
and netmask you recorded in
config system interface
edit internal
set mode static
set ip <address_ip> <netmask>
end
Example
config system interface
edit internal
set mode static
set ip 192.168.120.99 255.255.255.0
end
"Connecting to the CLI" on
Table 11 on page 36
Table 11 on page 36. Enter:
FortiGate-3000 and FortiGate-3600 FortiOS 3.0MR4 Install Guide
Configuring the FortiGate unit
to complete the
01-30004-0270-20070215