Fortinet FortiGate FortiGate-3000 Install Manual page 18

Powering on the FortiGate unit
18
After a few seconds, SYSTEM STARTING appears on the LCD.
The main menu setting appears on the LCD when the system is running.
Menu [ Fortigat -> ]
NAT, Standalone
The FortiGate unit starts and the Power LEDs light up.
Table 3: LED indicators
LED State
Power Green
Off
1, 2, 3, 4, Green
4/HA, 5/HA,
INT, EXT
Flashing
green
Off
1, 2, 3 Green
(Interfaces)
(10/100
Flashing
Interface) Green
Green
Off
Internal Amber
External
(gigabit copper
Flashing
Interfaces) amber
4/HA
Green
(Interface)
Off
Note: If only one power supply is connected, an audible alarm sounds to indicate a failed
power supply. Press the red alarm cancel button on the rear panel next to the power supply
to stop the alarm.
FortiGate-3000 and FortiGate-3600 FortiOS 3.0MR4 Install Guide
Description
The FortiGate unit is powered on.
The FortiGate unit is powered off.
The correct cable is in use, and the connected equipment has
power.
Network activity at this interface.
No link established.
The correct cable is in use, and the connected equipment has
power.
Network activity at this interface.
The interface is connected at 100 Mbps.
No link established.
The correct cable is in use, and the connected equipment has
power.
Network activity at this interface.
The interface is connected at 1000 Mbps.
No link established.
Installing the FortiGate unit
01-30004-0270-20070215