Verifying The Front Control Buttons And Lcd Configuration; Verify The Connection; Using The Command Line Interface; Configuring The Fortigate Unit To Operate In Nat/Route Mode - Fortinet FortiGate FortiGate-1000 Install Manual

Configuring the FortiGate unit

Using the command line interface

1
2
1
2
FortiGate-200, FortiGate-300, FortiGate-400, FortiGate-500 and FortiGate-1000 FortiOS 3.0 MR4 Install Guide
01-30004-0267-20070215

Verifying the front control buttons and LCD configuration

To verify the interface settings entered from the front control buttons and LCD, go
to the web-based manager, System > Network >Interface. The interface IP
addresses entered from the front control buttons and LCD should be displayed.

Verify the connection

To verify your connection, try the following:
• browse to www.fortinet.com
• retrieve or send email from your email account
If you cannot browse to the web site or retrieve/send email from your account,
review the previous steps to ensure all information was entered correctly and try
again.
You can also configure the FortiGate unit using the command line interface (CLI).
For information about connecting to the CLI, see
page 23.

Configuring the FortiGate unit to operate in NAT/Route mode

Use the information you gathered in
following procedures.
To add/change the administrator password
Log into the CLI.
Change the admin administrator password. Enter:
config system admin
edit admin
set password <psswrd>
end
To configure interfaces
Log into the CLI.
Set the IP address and netmask of the internal interface to the internal IP address
and netmask you recorded in
config system interface
edit <interface>
set mode static
set ip <address_ip> <netmask>
end
"Connecting to the CLI" on
Table 14 on page 35
Table 14 on page 35. Enter:
NAT/Route mode installation
to complete the
39