Dukane 8950W User Manual page 69

It e m
S E R V IC E
( c o n t i n u e d )
(continued on next page)
C O M M UNIC A TIO N TY PE
Select the communication type for transmission via
the C O NTR O L port.
NETWORK BRIDGE: Select this type, if it is
OFF: Select this mode to receive RS-232C
• OFF is selected as the default setting.
• When you select the NETWORK BRIDGE, check
the item, TRANSMISSION METHOD ( below).
S E R IA L S E TTING S
Select the serial communication condition for the
C O NTR O L port.
B A UD R A TE
C O M M UNIC A TIO N
( c o n t i n u e d )
• The BAUD RATE is fixed to 19200bps
and PARITY is fixed NONE when the
COMMUNICATION TYPE is set to OFF ( above).
TR A NS M IS S IO N M E TH O D
Select the transmission method for communication
by the NETWORK BRIDGE from the C O NTR O L
port.
HALF-DUPLEX: This method lets the projector
FULL-DUPLEX: This method lets the projector
• HALF-DUPLEX is selected as the default setting.
• If you select HALF-DUPLEX, check the setting of
the item RESPONSE LIMIT TIME ( 70).
D e s c r i p t i o n
required to control an external device as a
network terminal, via this projector from the
computer.
The C O NTR O L port doesn't accept RS-232C
commands (Ne t w o r k B r i d g e F u n c t i o n in the
Ne t w o r k G u i d e )
commands using the C O NTR O L port.
4800bps ó 9600bps ó 19200bps ó 38400bps
PA R ITY
NONE ó ODD ó EVEN
HALF-DUPLEX ó FULL-DUPLEX
make two way communication, but only one
direction, either transmitting or receiving data, is
allowed at a time.
make two way communication, transmitting and
receiving data at the same time.
OPTION menu
6 9