Mounting The Main Panel - Bosch MAP 5000 Series Installation Manual

36 en | Installation
Connecting the grounding cable to the hinged mounting plate
2.12

Mounting the main panel

This chapter describes the mounting of the following main panels:
–
–
–
–
How to mount the main panel
The main panel is mounted on the hinged mounting plate.
For information on how to mount modules on the hinged mounting plate, refer to Installing the
hinged mounting plate, page 33.
Ethernet cable
The Ethernet cable is used to provide a connection via Open Intrusion Interface (OII) to a
management system.
The Ethernet cable can alternatively be used for IP communication if one of the following main
panels is installed:
–
–
For IP communication via an integrated IP communicator the following protocols are available:
–
–
–
How to mount the Ethernet cable
1.
2019-09 | 25 | F.01U.168.332
MAP Main Panel (ICP-MAP5000-2)
MAP Main Panel with IP Communicator (ICP-MAP5000-COM) including the MAP GSM
module (ITS-MAP0008).
MAP Main Panel Small (ICP-MAP5000-S)
MAP Main Panel Small with IP Communicator (ICP-MAP5000-SC) including the MAP GSM
module (ITS-MAP0008).
MAP Main Panel with IP Communicator (ICP-MAP5000-COM)
MAP Main Panel Small with IP Communicator (ICP-MAP5000-SC)
VdS 2465-S2
SIA DC-09 (TCP/IP and UDP/IP)
Conettix IP
Feed the Ethernet cable through the large snap ferrite sleeve (supplied in the accessory
pack of the main panel) with an additional turn.
Installation manual
MAP 5000
Bosch Security Systems B.V.