Servicing The Fuses - Toro TimeCutter HD X5450 Operator's Manual

Figure 53
1. Battery
2. Negative (–) battery post
3. Bolt, washer, and nut for
the negative (–) battery
post
4. Bolt, washer, and nut for
the positive (+) battery
post
Charging the Battery
Service Interval: Before storage—Charge the battery and
disconnect the battery cables.
1. Remove the battery from the chassis; refer to
the Battery (page 38).
2. Charge the battery for a minimum of 1 hour at 6 to
10 A.
Note: Do not overcharge the battery.
3. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts
Figure 54
1. Positive (+) battery post
2. Negative (–) battery post
g188903
5. Positive (+) battery post
6. Terminal boot
7. Battery hold-down
Removing
(Figure 54).
g000538
3. Red (+) charger lead
4. Black (–) charger lead
Installing the Battery
1. Position the battery in the tray
2. Using the fasteners previously removed, install the
positive (red) battery cable to the positive (+) battery
terminal.
3. Using the fasteners previously removed, install the
negative battery cable to the negative (-) battery
terminal.
4. Slide the red terminal boot onto the positive (red)
battery post.
5. Secure the battery with the hold-down
6. Install the battery cover by pushing down and
tightening the 2 fasteners clockwise

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Fuse type:
•
Main—F1 (15 A, blade-type)
•
Charge Circuit—F2 (25 A, blade-type)
To replace the Main (15 A) fuse, reach into the opening in
the side of the console, pull out the fuse, and installed a new
15 A fuse (Figure 55).
1. Main (15 A)
To replace the Charge Circuit (25 A) fuse, locate the fuse to
the left of battery, pull out the fuse, and installed a new 25 A
fuse (Figure 56).
39
(Figure 53).
(Figure
(Figure 52).
Figure 55
2. Console opening
53).
g190588