Servicing The Spark Plug - Toro TimeCutter HD X5450 Operator's Manual

5. Change the engine-oil filter
Note: Ensure that the oil-filter gasket touches the
engine and then turn the filter an extra 3/4 turn.
A B
C D
F
E
g027477
Figure 46
6. Slowly pour approximately 80% of the specified oil
into the filler tube and slowly add the additional oil to
bring it to the Full mark
(Figure 46).
3/4
(Figure 47).
A
C
E

Servicing the Spark Plug

Service Interval: Every 100 hours/Yearly (whichever comes
Every 200 hours/Every 2 years (whichever comes
g027477
first)—Replace the spark plug(s).
Make sure that the air gap between the center and side
electrodes is correct before installing the spark plug. Use
a spark-plug wrench for removing and installing the spark
plug(s) and a gapping tool/feeler gauge to check and adjust
the air gap. Install a new spark plug(s) if necessary.
Type: Champion
Air gap: 0.76 mm (0.03 inch)
Removing the Spark Plug
1. Disengage the PTO and ensure that the parking brake
is engaged.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
35
B
D
F
Figure 47
first)—Check the spark plug(s).
® RN9YC or NGK ® BPR6ES
g027484
g027484