Roomanalytics Configuration; Xconfiguration Roomanalytics Peoplepresencedetector; Serialport Configuration; Xconfiguration Serialport Mode - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

RoomAnalytics configuration

xConfiguration RoomAnalytics PeoplePresenceDetector

The video system has the capability to find whether or not people are present in the room,
and report the result in the RoomAnalytics PeoplePresence status. This feature is based on
ultrasound. It takes a minimum of 2 minutes to detect whether people are present or not in the
room, and it may take up to 2 minutes for the status to change after the room becomes vacant.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: Off
USAGE:
xConfiguration RoomAnalytics PeoplePresenceDetector:
where
: Off/On
PeoplePresenceDetector
Off: The video system's status does not show whether or not there are people present
in the room.
On: The video system's status shows whether or not there are people present in the
room.
SX20 Codec API Reference Guide CE9.1, JUNE 2017.
D15316.07
About the API xConfiguration xConfiguration
PeoplePresenceDetector
xCommand

SerialPort configuration

xConfiguration SerialPort Mode

Enable/disable the serial port (connection via USB and RS-232 adapter).
Requires user role: ADMIN, INTEGRATOR
Default value: On
USAGE:
xConfiguration SerialPort Mode:
where
: Off/On
Mode
Off: Disable the serial port.
On: Enable the serial port.

xConfiguration SerialPort BaudRate

Define the baud rate (data transmission rate, bits per second) for the serial port.
Other connection parameters for the serial port are: Data bits: 8; Parity: None; Stop bits: 1; Flow
control: None.
Requires user role: ADMIN, INTEGRATOR
Default value: 38400
USAGE:
xConfiguration SerialPort BaudRate:
where
: 9600/19200/38400/57600/115200
BaudRate
Set a baud rate from the baud rates listed (bps).
68
API Reference Guide
xStatus Appendices
Mode
BaudRate
Copyright © 2017 Cisco Systems, Inc. All rights reserved.