Xcommand Camera Triggerautofocus; Conference Commands; Xcommand Conference Donotdisturb Activate; Xcommand Conference Donotdisturb Deactivate - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

xCommand Camera TriggerAutofocus

Trigger the auto-focus functionality. The camera must support auto-focus functionality. If the
camera is daisy chained, the CameraId is given by its place in the chain.
Requires user role: ADMIN, USER
USAGE:
xCommand Camera TriggerAutofocus CameraId:
where
: Integer (1..1)
CameraId
Select the camera to auto-focus.
SX20 Codec API Reference Guide CE9.1, JUNE 2017.
D15316.07
About the API xConfiguration
CameraId
xCommand xCommand

Conference commands

xCommand Conference DoNotDisturb Activate

This command switches on the Do Not Disturb mode, and the Timeout parameter allows you to
control when it is switched off again. When Do Not Disturb is switched on, all incoming calls are
rejected and registered as missed calls. The calling side receives a busy signal.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference DoNotDisturb Activate [Timeout: Timeout]
where
: Integer (1..1440)
Timeout
Set the number of minutes before Do Not Disturb is switched off. If not set, Do Not
Disturb times out after 1440 minutes (24 hours).

xCommand Conference DoNotDisturb Deactivate

Switch off the Do Not Disturb mode. When Do Not Disturb is switched off incoming calls come
through as normal.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference DoNotDisturb Deactivate

xCommand Conference SpeakerLock Release

Releases locked speaker set by xCommand Conference SpeakerLock Set. Default voice
switching is switched back on.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference SpeakerLock Release
105
API Reference Guide
xStatus Appendices
Copyright © 2017 Cisco Systems, Inc. All rights reserved.