Xconfiguration Video Output Connector [1..2] Cec Mode - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

xConfiguration Video Output Connector [1..2] CEC Mode

This video output (HDMI) supports Consumer Electronics Control (CEC). When this setting
is On, the system will use CEC to set the monitor in standby when the system itself enters
standby. Likewise the system will wake up the monitor when the system itself wakes up from
standby. For this to happen, the monitor that is connected to the output must be CEC compat-
ible and CEC must be configured on the monitor.
Note that the different manufacturers uses different marketing names for CEC, for example
Anynet+ (Samsung); Aquos Link (Sharp); BRAVIA Sync (Sony); HDMI-CEC (Hitachi); Kuro Link
(Pioneer); CE-Link and Regza Link (Toshiba); RIHD (Onkyo); HDAVI Control, EZ-Sync, VIERA Link
(Panasonic); EasyLink (Philips); and NetCommand for HDMI (Mitsubishi).
Requires user role: ADMIN, INTEGRATOR
Default value: Off
USAGE:
xConfiguration Video Output Connector
where
: Unique ID that identifies the video output connector. Range: 1..2
n
: Off/On
Mode
Off: CEC is disabled.
On: CEC is enabled.
SX20 Codec API Reference Guide CE9.1, JUNE 2017.
D15316.07
About the API xConfiguration xConfiguration
n CEC Mode: Mode
xCommand
xConfiguration Video Output Connector [1..2] MonitorRole
The monitor role describes which video streams will be shown on the monitor connected to this
video output connector. Together the Video Monitors setting and the MonitorRole settings for all
outputs define which layout (video streams) will be shown on each monitor.
Requires user role: ADMIN, INTEGRATOR
Default value: Connector [1]: First Connector [2]: Second
USAGE:
xConfiguration Video Output Connector
where
: Unique ID that identifies the video output connector. Range: 1..2
n
: Auto/First/Second/PresentationOnly
MonitorRole
Auto: The system will detect when a monitor is connected, and a monitor role
(First, Second) that corresponds with the Video Monitors setting will be assigned
automatically.
First/Second: Define the role of the monitor in a multi-monitor setup. In a single-monitor
setup, there is no difference between First and Second.
PresentationOnly: Show presentation video stream if active, and nothing else. Monitors/
outputs with this monitor role are disregarded by the Video Monitors setting.
84
API Reference Guide
xStatus Appendices
n MonitorRole: MonitorRole
Copyright © 2017 Cisco Systems, Inc. All rights reserved.