Xconfiguration Cameras Camera [1] Brightness Defaultlevel; Xconfiguration Cameras Camera [1] Flip; Xconfiguration Cameras Camera [1] Focus Mode; Xconfiguration Cameras Camera [1] Gamma Mode - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

xConfiguration Cameras Camera [1] Brightness DefaultLevel

Define the brightness level. Requires the Cameras Camera [n] Brightness Mode to be set to
Manual.
Requires user role: ADMIN, INTEGRATOR
Default value: 20
USAGE:
xConfiguration Cameras Camera n
where
: Unique ID that identifies the camera. Range: 1..1
n
: Integer (1..31)
DefaultLevel
The brightness level.

xConfiguration Cameras Camera [1] Flip

With Flip mode (vertical flip) you can flip the image upside down. Flipping applies both to the
self-view and the video that is transmitted to the far end.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
USAGE:
xConfiguration Cameras Camera n
where
: Unique ID that identifies the camera. Range: 1..1
n
: Auto/Off/On
Flip
Auto: If the camera detects that it is mounted upside down, the image is automatically
flipped. If the camera cannot auto-detect whether it is mounted upside down or not, the
image is not changed.
Off: Display the image on screen the normal way.
On: Display the image flipped upside down. This setting is used when a camera is
mounted upside down, but cannot automatically detect which way it is mounted.
SX20 Codec API Reference Guide CE9.1, JUNE 2017.
D15316.07
About the API xConfiguration xConfiguration
Brightness DefaultLevel: DefaultLevel
Flip: Flip
xCommand

xConfiguration Cameras Camera [1] Focus Mode

Define the camera focus mode.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
USAGE:
xConfiguration Cameras Camera
where
: Unique ID that identifies the camera. Range: 1..1
n
: Auto/Manual
Mode
Auto: The camera will auto focus once a call is connected, as well as after moving the
camera (pan, tilt, zoom). The system will use auto focus only for a few seconds to set
the right focus; then auto focus is turned off to prevent continuous focus adjustments of
the camera.
Manual: Turn the autofocus off and adjust the camera focus manually.

xConfiguration Cameras Camera [1] Gamma Mode

This setting enables gamma corrections, and applies only to cameras which support gamma
mode. Gamma describes the nonlinear relationship between image pixels and monitor
brightness.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
USAGE:
xConfiguration Cameras Camera
where
: Unique ID that identifies the camera. Range: 1..1
n
: Auto/Manual
Mode
Auto: Auto is the default and the recommended setting.
Manual: In manual mode the gamma value is changed with the gamma level setting, ref.
Cameras Camera [n] Gamma Level.
38
API Reference Guide
xStatus Appendices
n Focus Mode: Mode
n Gamma Mode: Mode
Copyright © 2017 Cisco Systems, Inc. All rights reserved.