Auto-Assemble Editing - Videonics AB-1 Edit Suite User Manual

For VCRs/camcorders using PANA or LANC protocol, you can have Edit Suite do this by
pressing [GO TO] +[0 (zero)]. (Zero is the SETUP key.) For most VCRs using RS-232 or
RS-422 protocol, Edit Suite will rewind the tape but not rezero the counter.
2. Manually place the record deck into Record Pause. (Use Play Pause for RS-422 VCRs.)
3. Press the VCR selector key (A, B, C, D) for the source you want to record.
4. Use the jog/shuttle or the transport keys to locate the scene you want to record.
5. Position the tape a few seconds before the scene and press the [PLAY] transport key.
6. At the start of the scene, press [REC].
Edit Suite will put the record VCR into Record. It will also create a Scene Event and fill in
the IN time with the time code that was current on the play VCR when REC was pressed.
7. At the end of the scene, press [OUT].
Edit Suite will put the record VCR into Record Pause. It will also add the OUT time to the
event.
8. Repeat Steps 3 through 7 for any other scenes you want to record. Step 2 may be
omitted if the next scene is from the same source.
9. After all scenes have been recorded/created, press [ALL STOP] to stop all VCRs/
camcorders.

Auto-Assemble Editing

1. If you are not using time code (RCTC, VITC, LTC), rewind your play VCRs/
camcorders and reset the counters before you begin marking scenes.
For VCRs/camcorders using PANA or LANC protocol, you can have Edit Suite do this by
pressing [GO TO] +[0 (zero)]. (Zero is also the SETUP key.) For VCRs using 232 or 422