Hardware Version:
Firmware Version:
Firmware Upgrade:
Ping Watch Dog
Ping Watch Dog sets the device to continuously ping a user-defined IP address (it can
be the Internet gateway, for example) to check the network connectivity. If there is a
connection failure then the device will automatically reboot.
Ping Watch Dog is dedicated to continuously monitoring the connectivity to a specific
host using the Ping tool. The Ping tool sends ICMP echo request packets to the target
host and listens for ICMP echo response. If the defined number of replies is not received,
the tool reboots the device.
Ping Watch Dog:
Destination IP
Address:
Ping Interval:
Figure 6-8 Firmware Upgrade
Display the current hardware version.
Display the current Firmware version.
Click Browse to locate and select the firmware file. Click Upload to
upload the file to upgrade. Do NOT power off your device while it is
upgrading.
Figure 6-9 Ping Watch Dog
Check the box to enable the feature.
Specify the IP address of the target host to which the Ping Watch
Dog Utility will send ping packets.
Enter the time interval (in seconds) between two successive ping
packets. The default value is 300 seconds.
26