Ping Watch Dog - TP-Link Auranet User Manual

After the firmware is uploaded, the page below will be shown. If you want to save the
current settings, please click Save Configuration. If you want to restore the device to
factory defaults please click Restore.
Hardware Version:
Firmware Version:
Firmware Upgrade:

Ping Watch Dog

Ping Watch Dog sets the device to continuously ping a user-defined IP address (it can
be the Internet gateway, for example) to check the network connectivity. If there is a
connection failure then the device will automatically reboot.
Ping Watch Dog is dedicated to continuously monitoring the connectivity to a specific
host using the Ping tool. The Ping tool sends ICMP echo request packets to the target
host and listens for ICMP echo response. If the defined number of replies is not received,
the tool reboots the device.
Ping Watch Dog:
Figure 6-8 Firmware Upgrade
Display the current hardware version.
Display the current Firmware version.
Click Browse to locate and select the firmware file. Click Upload to
upload the file to upgrade. Do NOT power off your device while it is
upgrading.
Figure 6-9 Ping Watch Dog
Check the box to enable the feature.
28