Loose Parts; Set-Up Instructions - Toro Groundsmaster 345 Operator's Manual

Note: Use this chart as a checklist to ensure all parts necessary for assembly have been shipped. If any of these parts
are missing, total set–up cannot be completed.
DESCRIPTION
Steering Wheel
Foam Seal
Nut
Screw
Cap
Manual Tube (shipped in tool box)
R–Clamp
Ball Joint R.H. (Shipped in tool box)
Operator's Manual (Traction Unit)
Parts Catalog
Engine Dealer Listing
Registration Card
Hydraulic Oil Filter
Specifications and design subject to change without notice.
INSTALL STEERING WHEEL
1. Remove jam nut from steering shaft. Slide foam
seal and steering wheel onto steering shaft.
2. Secure steering wheel to shaft with jam nut and
tighten it to 10–15 ft–lb.
3. Install cap to steering wheel with screw.
10

LOOSE PARTS

QTY.
1
1
1
1
1
1
2
1
2
1
1
1
1
SET–UP INSTRUCTIONS
USE
Install Steering Wheel
Install on right underside of seat
Install Ball Joint (implement installation)
and Connect Lift Cylinder.
Read before operating machine
Affixed to machine.
Change after 10 hours
Figure 1
1. Steering Wheel 4. Screw
2. Jam Nut 5. Foam Seal
3. Cap
4
3
2
1
5