Toshiba e-STUDIO 2000AC Copying Manual page 123

5.SAVING COPIED DATA AS A FILE
3 Enter file information and press [OK].
 MFP Local: Press this to store the data into the share folder of this equipment.
 Remote 1, Remote 2: Press either of them to store the data into the share folder of a PC that is connected with
this equipment via a network.
 File Name: Then enter the file name within 128 letters.
 File Format: Select the file format in which the data are stored from PDF, TIFF or XPS.
 Multi / Single: If you select [Multi], all the scanned data will be stored as one file. If you select [Single], a folder
is created and each page of the scanned data will be stored individually as one file in the folder.
 You can select up to 2 of [MFP Local], [Remote 1] and [Remote 2]. You can cancel the selected item by pressing
the same button again.
 When a user who has the privilege of changing the setting of [Remote 1] and [Remote 2] has pressed either of
them, the menu for specifying a directory appears. In this case, see the following page to specify the directory:
 P.124 "Setting share folder"
 The trailing characters in a file name (maximum 74) may be deleted depending on the type of letters used.
Press the [START] button on the control panel.
4
When the original is placed on the ADF, copying and storing start simultaneously.
When the original is placed on the original glass, follow the procedure below.
5 Place the next original on the original glass, and then press [Next Copy] on the touch panel or the
[START] button on the control panel.
Repeat this step until the scanning of all the originals is finished.
When all have been scanned, press [Job Finish] on the touch panel.
6
Copying and storing start.
Copying and Saving as a File 123