Resetting The Camera - Panasonic HomeHawk KX-HN1003 Installation Manual

Indoor home monitoring camera
Hide thumbs Also See for HomeHawk KX-HN1003:
Table of Contents

Advertisement

Setup
Resetting the
camera
Use this procedure if you have
trouble setting up the camera.
1
Plug in the camera.
2
Using an object with a thin tip,
press and hold the reset
button on the back of the
camera for about 10 seconds,
then release the button when
the camera beeps.
R The camera's settings are
3
Wait for the camera's LED to
light in green.
Note:
R After resetting the camera, you
cannot use the camera again
until it is set up. Refer to the
relevant page in this section to
set up the camera.
22
HN1003W_(en_en)_0302_ver001.pdf
reset.
For assistance, please visit http://shop.panasonic.com/support
22
2018/03/02
14:18:13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Homehawk kx-hnc800

Table of Contents