Fisher & Paykel OR36LDBGX1 Installation Instructions Manual page 21

SETTING THE BURNER MINIMUM
When switching from one type of gas to another, the minimum flow rate must also be
correct: the flame should not go out even when passing suddenly from maximum to
minimum flame.
To regulate the flame follow the instructions below:
Rapid and triple ring burners
– Light the burner
LO
– Set the gas valve to
– Remove the knob
– With a thin screwdriver pass by the hole of microswitch and turn the screw F until
adjustment is correct (fig. 2.7).
Inside crown of DUAL burner
– Light the DUAL burner
SIM
– Set the gas valve to position
– Remove the knob
– Using a screwdriver turn the screw H until the correct setting is obtained (fig. 2.8).
Outside crowns of DUAL burner
– Light the DUAL burner
LO
– Set the gas valve to
– Remove the knob
– Using a screwdriver turn the screw G until the correct setting is obtained (fig. 2.8).
For LP/PROPANE gas, tighten the adjustment screws completely.
position
position
F
Fig. 2.7
H
G
Fig. 2.8
2
21